Enable Timestamp On Syslog Messages; File Transfer Services; Configuration Task List For File Transfer Services - Dell Force10 MXL Blade Configuration Manual

Enable timestamp on Syslog Messages

By default, syslog messages do not include a time/date stamp stating when the error or message was
created.
To have FTOS include a timestamp with the syslog message, use the following command syntax in
CONFIGURATION mode:
Command Syntax
service timestamps [log | debug] [datetime
[localtime] [msec] [show-timezone] | uptime]
To view the configuration, enter the
To disable time stamping on syslog messages, enter the

File Transfer Services

With FTOS, you can configure the system to transfer files over the network using file transfer protocol
(FTP). One FTP application copies the system image files over an interface on to the system; however,
FTP is not supported on VLAN interfaces.
For more information about FTP, refer to

Configuration Task List for File Transfer Services

The following list includes the configuration tasks for file transfer services:
• Enable the FTP Server
• Configure the FTP Server Parameters
• Configure FTP Client Parameters
For a complete listing of FTP related commands, refer to
Command Mode
CONFIGURATION
show running-config logging
RFC 959, File Transfer Protocol.
(mandatory)
(optional)
(optional)
Purpose
Add timestamp to syslog messages. Specify
the following optional parameters:
• datetime : You can add the keyword
localtime to include the localtime, msec,
and show-timezone . If you do not add the
keyword localtime , the time is UTC.
• uptime . To view time since last boot.
If neither parameter is specified, FTOS
configures uptime .
command in EXEC privilege mode.
no service timestamps [log | debug]
RFC 959, File Transfer Protocol.
command.
Management | 61