Task
Set the delay time for VRRP initialization on an
individual interface. This is the gap between an
interface coming up and being operational, and
VRRP enabling.
Seconds range: 0-900
Default: 0
Set the delay time for VRRP initialization on all
the interfaces in the system configured for
VRRP. This is the gap between system boot up
completion and VRRP enabling.
Seconds range: 0-900
Default: 0
Sample Configurations
VRRP for IPv4 Configuration
The configuration in
comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You
can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your
own IP addresses, interfaces, names, etc.
configuration in
646
|
Virtual Router Redundancy Protocol (VRRP)
Command Syntax
vrrp delay minimum seconds
vrrp delay reload seconds
Figure 38-19
shows how to enable IPv4 VRRP. This example does not contain
Figure
38-20.
Figure 38-19
shows the VRRP topology created with the CLI
Command Mode
INTERFACE
INTERFACE