Dell Force10 MXL Blade Configuration Manual page 389

Figure 21-2. Number of Monitoring Ports
FTOS(conf)#mon ses 300
FTOS(conf-mon-sess-300)#source tengig 0/17 destination tengig 0/4 direction tx
% Error: Exceeding max MG ports for this MD port pipe.
FTOS(conf-mon-sess-300)#
FTOS(conf-mon-sess-300)#source tengig 0/17 destination tengig 0/1 direction tx
FTOS(conf-mon-sess-300)#do show mon session
SessionID
---------
0
10
20
30
300
In Figure 21-3, 0/25 and 0/26 belong to Port-pipe 1. This port-pipe again has the same restriction of only
four destination ports, new or used.
Figure 21-3. Number of Monitoring Ports
FTOS(conf-mon-sess-300)#do show mon session
SessionID
---------
0
10
20
30
100
110
300
FTOS(conf-mon-sess-300)#
A source port may only be monitored by one destination port
monitor more than one source port.
Message 3 One Destination Port in a Monitoring Session Error Message
% Error: Exceeding max MG ports for this MD port pipe.
Message 4 One Destination Port per Source Port Error Message
% Error: MD port is already being monitored.
Source Destination
------ -----------
TenGig 0/13 TenGig 0/1
TenGig 0/14 TenGig 0/2
TenGig 0/15 TenGig 0/3
TenGig 0/16 TenGig 0/37
TenGig 0/17 TenGig 0/1
Source Destination
------ -----------
TenGig 0/13 TenGig 0/1
TenGig 0/14 TenGig 0/2
TenGig 0/15 TenGig 0/3
TenGig 0/16 TenGig 0/37
TenGig 0/25 TenGig 0/38
TenGig 0/26 TenGig 0/39
TenGig 0/17 TenGig 0/1
Direction Mode
--------- ----
rx interface
rx interface
rx interface
rx interface
tx interface
Direction Mode
--------- ----
rx interface
rx interface
rx interface
rx interface
tx interface
tx interface
tx interface
(Message 3), but a destination port may
Type
----
Port-based
Port-based
Port-based
Port-based
Port-based
Type
----
Port-based
Port-based
Port-based
Port-based
Port-based
Port-based
Port-based
Port Monitoring | 387