Configure A Username And Password; Configuration Task List For Privilege Levels - Dell Force10 MXL Blade Configuration Manual

Privilege levels 2 through 14 are not configured and you can customize them for different users and access.
After you configure other privilege levels, enter those levels by adding the level parameter after the
command or by configuring a user name or password that corresponds to the privilege level. For more
information about configuring user names, refer to
By default, commands in FTOS are assigned to different privilege levels. You can access those commands
only if you have access to that privilege level. For example, to reach the
you must log in to the router, enter the
the command) and then enter CONFIGURATION mode.
You can configure passwords to control access to the box and assign different privilege levels to users.
FTOS supports the use of passwords when you log in to the system and when you enter the
command. You can move between privilege levels, you are prompted for a password if you move to a
higher privilege level.

Configuration Task List for Privilege Levels

The following list has the configuration tasks for privilege levels and passwords.
•

Configure a Username and Password

• Configure the Enable Password Command
• Configure Custom Privilege Levels
• Specify the LINE Mode Password and Privilege
• Enable and Disable Privilege Levels
For a complete listing of all commands related to FTOS privilege levels and passwords, refer to the
Security chapter in the FTOS Command Reference Guide.
Configure a Username and Password
In FTOS, you can assign a specific username to limit user access to the system.
480
| Security
Configure a Username and
command for privilege level 15 (this is the default level for
enable
(mandatory)
(mandatory)
(mandatory)
(optional)
(optional)
Password.
command,
protocol spanning-tree
enable
enable