Dell Force10 MXL Blade Configuration Manual page 521

Figure 30-2. Select a User-based Security Type
FTOS(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 ?
auth
noauth
priv
FTOS(conf)#snmp-server host 1.1.1.1 traps version 3 noauth ?
WORD
To set up a user with view privileges only (no password or privacy privileges):
Task
Configure the user.
Configure an SNMP group.
Configure an SNMPv3 view.
To set up a user with password privileges only, use the following commands:
Task
Configure the user with an authorization
password
Configure an SNMP group.
Configure an SNMPv3 view.
To set up a user with password or privacy privileges:
Task
Configure an SNMP group.
Configure the user with a secure
authorization password and
privacy password.
Configure an SNMPv3 view.
Use the SNMPv3 authNoPriv Security Level
Use the SNMPv3 noAuthNoPriv Security Level
Use the SNMPv3 authPriv Security Level
SNMPv3 user name
Command
snmp-server user name group-name 3 noauth
snmp-server group group-name 3 noauth auth
read name write name
snmp-server view view-name oid-tree
excluded
Note: To give a user read and write view privileges,
repeat this step for each privilege type.
Command
snmp-server user name group-name 3 noauth
auth md5 auth-password
snmp-server group groupname {oid-tree} auth
read name write name
snmp-server view view-name 3 noauth
excluded
Note: To give a user read and write privileges,
repeat this step for each privilege type.
Command
snmp-server group group-name {oid-tree} priv
read name write name
snmp-server user name group-name {oid-tree}
auth md5 auth-password priv des56 priv password
snmp-server view view-name oid-tree
excluded
}
}
}
Simple Network Management Protocol (SNMP) | 519
Command Mode
CONFIGURATION
CONFIGURATION
included
{ | CONFIGURATION
Command Mode
CONFIGURATION
CONFIGURATION
included
{ | CONFIGURATION
Command Mode
CONFIGURATION
CONFIGURATION
included
{ | CONFIGURATION