Dell Force10 MXL Blade Configuration Manual page 640

To configure a virtual IP address, follow these steps:
Step Task
1 Configure a VRRP group.
VRID Range: 1 to 255
2 Configure virtual IP addresses
for this VRID.
Range: up to 12 addresses
Figure 38-4. virtual-address Command Example
FTOS(conf-if-te-1/1-vrid-111)#virtual-address 10.10.10.1
FTOS(conf-if-te-1/1-vrid-111)#virtual-address 10.10.10.2
FTOS(conf-if-te-1/1-vrid-111)#virtual-address 10.10.10.3
FTOS(conf-if-te-1/1-vrid-111)#
Figure 38-5. show config Command Example
FTOS(conf-if-te-1/1)#show conf
!
interface Tengigabitethernet 1/1
ip address 10.10.10.1/24
!
vrrp-group 111
priority 255
virtual-address
virtual-address
virtual-address
!
vrrp-group 222
no shutdown
FTOS(conf-if-te-1/1)#
638
| Virtual Router Redundancy Protocol (VRRP)
Command Syntax
vrrp-group vrrp-id
virtual-address ip-address1 [...ip-address12]
10.10.10.1
10.10.10.2
10.10.10.3
Note that the Primary IP address
and the Virtual IP addresses are
on the same subnet
Command Mode
INTERFACE
INTERFACE -VRID