Note: When creating an interface range, interfaces appear in the order they were entered and are not
sorted.
To display all interfaces that have been validated under the interface range context, use the
command in Interface Range mode.
To display the running configuration only for interfaces that are part of interface range, use the
command in Interface Range mode.
configuration
Bulk Configuration Examples
The following are examples of using the
•
Create a Single-Range
•
Create a Multiple-Range
•
Exclude Duplicate Entries
•
Exclude a Smaller Port Range
•
Overlap Port Ranges
•
Commas
•
Add Ranges
Create a Single-Range
Figure 13-15. Creating a Single-Range Bulk Configuration
FTOS(conf)# interface range tengigabitethernet 5/1 - 23
FTOS(conf-if-range-te-5/1-23)# no shutdown
FTOS(conf-if-range-te-5/1-23)#
Create a Multiple-Range
Figure 13-16. Creating a Multiple-Range Prompt
FTOS(conf)#interface range tengigabitethernet 3/0 , tengigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-te-2/1-47)#
Exclude Duplicate Entries
Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt.
command for bulk configuration:
interface range
show range
show
Interfaces | 239