•
Generate a Default Route
•
Control Route Metrics
•
Summarize Routes
•
Control Route Metrics
•
Debug RIP
For a complete listing of all commands related to RIP, refer to the
Enable RIP Globally
By default, RIP is not enabled in FTOS. To enable RIP, use the following commands in sequence, starting
in CONFIGURATION mode:
Step
Command Syntax
1
router rip
2
network ip-address
After designating the networks that the system is to exchange RIP information, ensure that all devices on
that network are configured to exchange RIP information.
The FTOS default is to send RIPv1, and to receive RIPv1 and RIPv2. To change the RIP version globally,
use the
command in ROUTER RIP mode.
version
After you enable RIP, to view the global RIP configuration, use the
mode or the
show config
Figure 25-1. show config Command Example (ROUTER RIP Mode)
FTOS(conf-router_rip)#show config
!
router rip
network 10.0.0.0
FTOS(conf-router_rip)#
(optional)
(optional)
(optional)
Command Mode
CONFIGURATION
ROUTER RIP
command
(Figure 25-1)
FTOS Command Reference Guide.
Purpose
Enter ROUTER RIP mode and enable the RIP process
on FTOS.
Assign an IP network address as a RIP network to
exchange routing information.
You can use this command multiple times to exchange
RIP information with as many RIP networks as you
want.
show running-config
in ROUTER RIP mode.
command in EXEC
Routing Information Protocol (RIP) | 437