VRRP Configuration
By default, VRRP is not configured.
Configuration Task List for VRRP
The following list specifies the configuration tasks for VRRP:
•
Create a Virtual Router
•
Assign Virtual IP addresses
•
Set the VRRP Group (Virtual Router) Priority
•
Configure VRRP Authentication
•
Disable Preempt
•
Change the Advertisement Interval
•
Track an Interface or Object
•
VRRP Initialization Delay
For a complete listing of all commands related to VRRP, refer to FTOS Command Line Interface Guide.
Create a Virtual Router
To enable VRRP, you must create a virtual router. In FTOS, a VRRP group is identified by the virtual
router identifier (VRID).
To enable a virtual router, use the following command in INTERFACE mode
VRRP group, use the
Task
Create a virtual router for that interface
with a VRID.
VRID Range: 1 to 255
Figure 38-2. vrrp-group Command Example
FTOS(conf)#int tengig 1/1
FTOS(conf-if-te-1/1)#vrrp-group
FTOS(conf-if-te-1/1-vrid-111)#
636
|
Virtual Router Redundancy Protocol (VRRP)
(mandatory)
(mandatory)
(optional)
(optional)
(optional)
(optional)
command in INTERFACE mode.
no vrrp-group vrid
Command Syntax
vrrp-group vrid
Note: The interface must already have a Primary IP Address defined and
be enabled.
111
(optional)
Command Mode
INTERFACE
Virtual Router ID
and VRRP Group identifier
(Figure
38-2). To delete a