Assign Virtual Ip Addresses - Dell Force10 MXL Blade Configuration Manual

Configuration guide for the mxl 10/40gbe switch io module
Hide thumbs Also See for Force10 MXL Blade:
Table of Contents

Advertisement

Figure 38-3. show config Command Example
FTOS(conf-if-te-1/1)#show conf
!
interface Tengigabitethernet 1/1
ip address 10.10.10.1/24
!
vrrp-group 111
no shutdown
FTOS(conf-if-te-1/1)#

Assign Virtual IP addresses

Virtual routers contain virtual IP addresses configured for that VRRP group (VRID). A VRRP group does
not transmit VRRP packets until you assign the virtual IP address to the VRRP group.
To activate a VRRP group on an interface (so that VRRP group starts transmitting VRRP packets),
configure at least one virtual IP address in a VRRP group. The virtual IP address is the IP address of the
virtual router and does not require the IP address mask.
You can configure up to 12 virtual IP addresses on a single VRRP group (VRID).
The following rules apply to virtual IP addresses:
The virtual IP addresses must be in the same subnet as the primary or secondary IP addresses
configured on the interface. Though a single VRRP group can contain virtual IP addresses belonging
to multiple IP subnets configured on the interface, Dell Force10 recommends configuring virtual IP
addresses belonging to the same IP subnet for any one VRRP group.
For example, an interface (on which VRRP is to be enabled) contains a primary IP address of
50.1.1.1/24 and a secondary IP address of 60.1.1.1/24. The VRRP group (VRID 1) must contain
virtual addresses belonging to either subnet 50.1.1.0/24 or subnet 60.1.1.0/24, but not from both
subnets (though FTOS allows the same).
If the virtual IP address and the interface's primary/secondary IP address are the same, the priority on
that VRRP group MUST be set to 255. The interface then becomes the OWNER router of the VRRP
group and the interface's physical MAC address is changed to that of the owner VRRP group's MAC
address.
If you configure multiple VRRP groups on an interface, only one of the VRRP groups can contain the
interface primary or secondary IP address.
Note that the interface
has an IP Address and is enabled
Virtual Router Redundancy Protocol (VRRP) | 637

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents