Configuring Lldpdu Intervals - Dell Force10 MXL Blade Configuration Manual

Configuring LLDPDU Intervals

LLDPDUs are transmitted periodically; the default interval is 30 seconds. To configure a non-default
transmit interval—at CONFIGURATION level or INTERFACE level—use the
(Figure 18-13).
Figure 18-13. Configuring LLDPDU Transmit and Receive Mode
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#mode ?
rx
tx
R1(conf-lldp)#mode tx
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
mode tx
no disable
R1(conf-lldp)#no mode
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#
Rx only
Tx only
command
hello
Link Layer Discovery Protocol (LLDP) | 327