The flow-control sender and receiver must be on the same port-pipe. Flow control is not supported across
different port-pipes (also refer to
Command Syntax
flowcontrol rx [off | on] tx [off | on] [threshold
{<1-2047> <1-2013> <1-2013>}]
Note: After you disable DCB, if link-level flow control is not automatically enabled on an interface,
manually shut down the interface (
enable flow control.
Configure MTU Size on an Interface
If a packet includes a Layer 2 header, the difference in bytes between the link MTU and IP MTU must be
enough to include the Layer 2 header. For example, for VLAN packets, if the IP MTU is 1400, the link
MTU must be no less than 1422:
1400-byte IP MTU + 22-byte VLAN Tag = 1422-byte link MTU
The MTU range is 592-12000, with a default of 1554.
248
|
Interfaces
Enabling and Disabling iSCSI Optimization on page
Command Mode
INTERFACE
Parameters:
rx on
: Enter the keywords
frames on this port.
rx off
: Enter the keywords
frames on this port.
tx on
: Enter the keywords
to the connected device when a higher rate of traffic is received.
tx off
: Enter the keywords
sent from this port to the connected device when a higher rate of traffic
is received.
shutdown
command) and re-enable it (
281).
Purpose
Control how the system responds to and
generates 802.3x pause frames on 10 and
40Gig ports.
Defaults:
ff
rx o
rx on
to process the received flow control
rx off
to ignore the received flow control
tx on
to send control frames from this port
tx off
so that flow control frames are not
no shutdown
command) to