Show sFlow on a Stack Unit
To view sFlow statistics on a specified stack unit, use the following command
Command Syntax
show sflow stack-unit
unit-number
Figure 29-4. show sflow stack unit Command Example
FTOS#show sflow stack-unit 1
Stack-Unit 1
Samples rcvd from h/w
Total UDP packets exported
UDP packets exported via RPM
UDP packets dropped
FTOS#
Specify Collectors
The
sflow collector
forwarded. You can specify up to two sFlow collectors. If you specify two collectors, the samples are sent
to both.
To identify sFlow collectors, use the following command:
Command Syntax
sflow collector ip-address agent-addr
ip-address [number
[max-datagram-size number] ] |
[max-datagram-size number ]
Polling Intervals
The
sflow polling-interval
of seconds between successive samples of counters to be sent to the collector. This command changes the
global default counter polling (20 seconds) interval. You can configure an interface to use a different
polling interval.
You can configure the polling interval globally (in CONFIGURATION mode) or by interface (in
INTERFACE mode) by executing the following
Command Mode
EXEC
:0
:0
:0
:0
command allows identification of sFlow collectors to which sFlow datagrams are
Command Mode
CONFIGURATION
command configures the polling interval for an interface in the maximum number
Purpose
Display sFlow configuration information and statistics on
the specified interface.
Usage
Identify sFlow collectors to which sFlow datagrams
are forwarded.
Default UDP port: 6343
Default max-datagram-size: 1400
command:
interval
(Figure
29-4):
sFlow | 509