Dell Force10 MXL Blade Configuration Manual page 104

Use reload mode to boot up, the system remains in the system memory. If the system undergoes an
automatic reload, it reloads using the previously used mode. To use a different mode when the system
reloads automatically, reboot the system in a new mode. The new mode is then retained in system memory.
To view the current reload mode, use the
(Figure 6-2).
Figure 6-1. Command Example: show reload type (normal)
FTOS#show reload-type
Reload-Type
FTOS#show bootvar
PRIMARY IMAGE FILE =
SECONDARY IMAGE FILE =
DEFAULT IMAGE FILE =
LOCAL CONFIG FILE =
PRIMARY HOST CONFIG FILE =
SECONDARY HOST CONFIG FILE =
PRIMARY NETWORK CONFIG FILE =
SECONDARY NETWORK CONFIG FILE =
CURRENT IMAGE FILE =
CURRENT CONFIG FILE 1 =
CURRENT CONFIG FILE 2 =
CONFIG LOAD PREFERENCE =
BOOT INTERFACE GATEWAY IP ADDRESS =
Reload Mode =
Figure 6-2. Command Example: show reload type (jumpstart)
FTOS#show reload-type
Reload-Type
auto-save
config-download
dhcp-timeout
retry-count
FTOS#
FTOS#show boot jumpstart
Config download enabled via DHCP/BOOTP
Autoconfig State : Autoconfig process has started
Autoconfig State : Waiting for boot options
FTOS#
102
| Bare Metal Provisioning (BMP)
: normal-reload [Next boot : normal-reload]
tftp://10.11.9.3/WJ_m1000e-2-c2
variable does not exist
variable does not exist
variable does not exist
variable does not exist
variable does not exist
variable does not exist
variable does not exist
tftp://10.11.9.3/WJ_m1000e-2-c2
flash://startup-config
variable does not exist
local first
10.11.9.254
normal-reload
: jump-start [Next boot :jump-start]
: disable
: enable
: 50
: 1
or
show reload type show bootvar
command (Figure 6-1) and