Verifying A Stack Configuration; Using Leds; Using Show Commands - Dell Force10 MXL Blade Configuration Manual

Reset a Unit on a Stack
Use the following reset commands to reload any of the member units or the standby in a stack. If you try to
reset the stack master, an error message is displayed:
Task
Reload a stack unit from the master switch
Reload a member unit from the unit itself.
Reset a stack-unit when the unit is in a problem state.

Verifying a Stack Configuration

Using LEDs

Table 31-1
diodes (LEDs) on its front panel.
Table 31-1. System Status LED on a Stacked Switch
Color
Blue
Off
Amber

Using Show Commands

To display information on the stack configuration, use the
switch.
Table 31-2. Displaying Stack Configurations
Command
show system [brief]
(Figure 31-8 and
show inventory optional-module
show system stack-unit
configured (Figure
show system stack-unit
(Figure 31-12)
560
| Stacking
lists the status of a stacked switch according to the color of the System Status light emitting
Meaning
The switch is operating as the stack master or as a standalone unit.
The switch is a member or standby unit.
The switch is booting or a failure condition has occurred.
Figure 31-9)
(Figure 31-10)
unit-number stack-group
31-11)
unit-number stack-group
Reset of master unit is not allowed.
Command Syntax
reset stack-unit unit-number
reset-self
reset stack-unit unit-number
hard
commands in
show
Output
Displays stacking roles (master, standby, and member units) and
the stack MAC address.
Displays the FlexIO modules currently installed in expansion
slots 0 and 1 on a switch and the expected module logically
provisioned for the slot.
Displays the stack groups allocated on a stacked switch. Valid
stack-unit numbers: 0 to 5.
Displays the port numbers that correspond to the stack groups on
a switch. Valid stack-unit numbers: 0 to 5.
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
Table 31-2 on the master