Disable Preempt - Dell Force10 MXL Blade Configuration Manual

To configure simple authentication, use the following command:
Task
Configure a simple text password.
Parameters:
encryption-type: 0 indicates
unencrypted; 7 indicates encrypted
password: plain text
Figure 38-9. authentication-type Command Example
FTOS(conf-if-te-1/1-vrid-111)#authentication-type ?
FTOS(conf-if-te-1/1-vrid-111)#authentication-type simple
Figure 38-10. show config Command Example (a Simple Password is Configured)
FTOS(conf-if-te-1/1-vrid-111)#show conf
!
vrrp-group 111
authentication-type simple 7
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
FTOS(conf-if-te-1/1-vrid-111)#

Disable Preempt

The command is enabled by default. The command forces the system to change the MASTER
preempt
router if another router with a higher priority comes online.
To prevent the BACKUP router with the higher priority from becoming the MASTER router, disable the
command.
preempt
Note: You must configure all virtual routers in the VRRP group at the same: all configured with preempt
enabled or configured with preempt disabled.
Command Syntax
authentication-type simple [encryption-type]
password
Encryption type
(encrypted)
387a7f2df5969da4
Command Mode
INTERFACE-VRID
7 force10
Password
Encrypted password
Virtual Router Redundancy Protocol (VRRP) | 641