Dell Force10 MXL Blade Configuration Manual page 96

You can create multiple instances of this route map using the sequence number option to place the route
maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a
configured route map is applied to a command, such as
that route map until a match is found.
Figure 5-24. Command Example: show route-map with Multiple Instances of a Route Map
FTOS#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface
Set clauses:
tag 35
level
FTOS#
To delete all instances of that route map, use the
instance, add the sequence number to the command syntax
Figure 5-25. Deleting One Instance of a Route Map
FTOS(conf)#no route-map zakho 10
FTOS(conf)#end
FTOS#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface
Set clauses:
tag 35
level
FTOS#
Figure 5-26
only the configuration of the current route map instance. To view all instances of a specific route map, use
the
show route-map
Figure 5-26. Command Example: show route-map
FTOS#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface
Set clauses:
tag
FTOS#
To delete a route map, use the
94
| Access Control Lists (ACLs)
TenGigabitEthernet 0/1
stub-area
TenGigabitEthernet 0/1
stub-area
shows an example of a route map with multiple instances. The
command.
Loopback 23
3444
no route-map map-name
redistribute
Figure 5-24 shows an example with two instances of a route map.
Route map zakho has two instances
no route-map map-name
(Figure
command in CONFIGURATION mode.
, traffic passes through all instances of
command. To delete just one
5-25).
command displays
show config