Run The Configuration Wizard; Configuring The Network - Dell EMC PowerProtect DD6400 System Expansion Manuallines

system show eula

Run the configuration wizard

There are two wizards, a DD System Manager configuration wizard and a Command Line Interface (CLI) configuration wizard.
The configuration wizards guide you through a simplified configuration of the system to get the system operating quickly.
Command Line Interface (CLI) configuration wizard
The CLI configuration wizard starts automatically the first time the system starts. The wizard prompts you through a series of
questions that provide just enough information for initial system configuration and basic network connectivity.
You can begin the CLI configuration wizard manually by typing config setup.
After you complete the basic configuration with a wizard, you can use additional configuration controls in DD System Manager
and the CLI to further configure the system.
DD System Manager configuration wizard
DD System Manager provides a single, consolidated management interface that allows for configuration and monitoring of many
system features and system settings.

Configuring the network

Prerequisites
To avoid IP address conflicts with the DDOS-iDRAC interconnect, do not configure 169.254.0.<X> and 169.254.1.<X> IP
addresses.
Steps
1. Enter yes to configure the system for network connectivity.
Network Configuration
Configure Network at this time (yes|no) [no]:
yes
2. Enter yes to configure DHCP (Dynamic Host Configuration Protocol) to obtain network parameters (such as, the host
name, domain name, and IP addresses) dynamically from a DHCP server. Or enter no to configure the parameters manually.
Use DHCP
Use DHCP for hostname, domainname, default gateway
and DNS servers? (At least one interface needs to
be configured using DHCP)
3. Enter a fully qualified domain name (FQDN) for the host name; for example, str01.yourcompany.com. Or accept the
host name, if the system was able to discover it.
Enter the hostname for this system
(fully-qualified domain name)[]:
4. Enter the DNS (Domain Name System) domain name; for example, yourcompany.com. Or accept the domain name, if the
system was able to discover it.
Domainname
Enter your DNS domainname []:
5. Enable and configure each Ethernet interface. Accept or decline DHCP for each interface. If the port does not use DHCP to
discover network parameters automatically, enter the information manually.
Ethernet port ethMa
Enable Ethernet port ethMa (yes|no|?) [no]:
yes
(yes|no|?)
Configure System for Use 35