Reviewing Troubles And Alarm Memory; Alarm & Tamper Memory Indication; Clearing The Memory Indication; Troubles - Visonic rMaster-360 User Manual

Hide thumbs

Table of Contents

3. Reviewing events and alarm memory

Alarm and tamper memory history

The PowerMaster-360 retains in its memory alarm and "tamper" events that occurred during the last arming

period.

Note: Alarm events are memorized only after the "abort period" (see Appendix C). This means that if you disarm

the system immediately - before the abort period expires - there will be no memory indication

A. Indication of alarm and tamper condition

If the system is disarmed following an alarm event, a flashing MEMORY message will be displayed, as follows:

READY

HH:MM

(alternating)

READY

MEMORY

B. Displaying alarm and tamper information

To review memory content, click

EXAMPLE: An alarm was triggered because the garage door - zone No. 12 – was opened but then closed. In

addition, the bedroom motion detector - zone No. 7 - sent a "Tamper" message because its cover had been

removed.

PRESS

RESULTING DISPLAY

In response to additional clicking of the

open tamper (if any), or reverts to its initial state (see A above).

If the system is NOT READY, the display will first read the open zones and then alarm memory events.

Clearing the memory history

To clear the 'Memory' history you must first review the cause of alarm as described above. After you return to

the 'Ready' screen simply press Away

followed by the code. The memory message is now cleared. Otherwise the memory indication and content are

cleared when the system is next armed.

Problems with enrolled devices

A. Indication that a trouble condition (TRBL) is detected by the system

If the system detected a problem with any of the enrolled devices, the problem indicator on the Virtual Keypad

illuminates, 3 beeps are sounded via the Virtual Keypad once per minute and a flashing TRBL message is

displayed, as follows.

READY

HH:MM

(alternating)

READY

TRBL

or, if the system is not ready for arming

B. Displaying problems

All TRBL messages need to be reviewed and corrected as described below:

EXAMPLE: The kitchen device - zone No. 9 - has reported a low battery – the living room device zone No. 15 -

has been inactive, and an attempt to communicate a message to your telephone has failed. However, these

troubles do not prevent the system from being "ready to arm".

D-307082 PowerMaster 360 User's Guide