Table of Contents
Advertisement
The first device type is displayed, "CONTACT SENSORS".
4.
Press the
SENSORS", "MOTION SENSORS", "SMOKE SENSORS", "KEYFOBS", "SIRENS" or
"REPEATERS", for example, "MOTION SENSORS".
5.
After making your selection, press the
The PowerMax10-G2 display will read the device name alternating with the
location.
Press the
6.
I
OK
001] or [ACTIVATE NOW Uxx] for keyfobs.
After testing the PowerMax10-G2 display will then automatically change to read
the average level for the last 24 hours (for stationary devices) or the number of
activations that the control panel has received (for keyfobs).
The signal strength indications are as follows: "
"
"; "
" (poor communication is detected between the device and the
BAD
BAD COM
control panel); "
NO COM
without any performed test); "
networked); "
NONE
without statistics).
Pressing the
you to "
<OK> TO EXIT
5.1.3 Displaying Signal Strength Indication of All Devices
1.
Repeat steps 1 to 6 from section 5.1.1 Testing all Devices.
2.
When the PowerMax10-G2 display reads [TEST ALL DEVICES], press the
and
read [SHOW ALL DEVICES].
3.
When the PowerMax10-G2 display reads [SHOW ALL DEVICES], press the
button.
I
OK
The PowerMax10-G2 display switches between the average signal strength
indication for the last 24 hours and between the current signal strength
indications of the first device type.∗
4.
Press the
device type.∗
The signal strength indications are as follows: "
"
" (poor communication is detected between the device and the control
BAD COM
panel); "
." (no communication); "
NO COM
any performed test); "
"
" (keyfob 24Hr result); or "
NONE
statistics).
∗
Pressing the
which the signal strength indications refer.
Pressing the
you to "
<OK> TO EXIT
5.1.4 Displaying Signal Strength Indication of RF Devices
Repeat steps 1 to 6 from section 5.1.1 Testing all Devices.
1.
2.
When the PowerMax10-G2 display reads [TEST ALL DEVICES], press the
or
D-302756
or
button repeatedly to select between "CONTACT
I
OK
button. The PowerMax10-G2 display will read [TESTING Zxx
." (no communication); "
NOT NET
" (keyfob 24Hr result); or "
or
buttons at any stage in the procedure will take
".
buttons repeatedly until the PowerMax10-G2 display will
button to view the signal strength indications for the next
NOT TST
" (device is pre-enrolled – not networked);
NOT NET
EARLY
button will display the number and type of device to
I
OK
or
buttons at any stage in the procedure will take
".
button repeatedly until the PowerMax10-G2 display will read
button.
";
STRONG
GOOD
" (results are shown
NOT TST
" (device is pre-enrolled – not
" (result of the last 24Hrs
EARLY
";
"; "
STRONG
GOOD
POOR
" (results are shown without
" (result of the last 24Hrs without
"; "
";
POOR
"; "
";
BAD
I
OK
CONTACT SENSORS
or
MOTION SENSORS
I
OK
Zxx:Motion Sens
Front door
I
OK
TESTING Zxx 001
or
ACTIVATE NOW Uxx
Z01 NOW: STRONG
Z01 24Hr: EARLY
TEST ALL DEVICES
or
SHOW ALL DEVICES
I
OK
Z01: 24hr: GOOD
Z01 NOW: NOT TST
K01: 24hr: NONE
K01: NOW: NONE
TEST ALL DEVICES
or
63
Advertisement
Table of Contents
