Chapter 56: System Log Command List - Extreme Networks EAS 200-24p Switch CLI Manual

56
C H A P T E R
●
clear log
●
show log {[index <value_list> | severity {module <module_list>} {emergency | alert
| critical | error | warning | notice | informational | debug | <level_list 0-7>}
| module<module_list>]}
●
show log_software_module
●
enable syslog
●
disable syslog
●
show syslog
●
config syslog host
| warning | notice | informational | debug | <level 0-7>] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] | state [enable | disable]}
●
create syslog host
[emergency | alert | critical | error | warning | notice | informational | debug
| <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | state [enable | disable]}
●
delete syslog host
v
●
show syslog host
●
config log_save_timing
●
show log_save_timing
●
show attack_log {index <value_list>}
●
clear attack_log
Extreme Networks EAS 200-24p Switch CLI Manual
System Log Command List
[<index> | all] {severity [emergency | alert | critical | error
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity
[<index 1-4> | all]
[time_interval <min 1-65535> | on_demand | log_trigger]
783