Chapter 1: Using The Command-Line Interface; Accessing The Switch Via The Serial Port - Extreme Networks EAS 200-24p Switch CLI Manual

1
C H A P T E R
The switch can be managed through the switch's serial port, Telnet, SNMP or the web-based
management agent. The command-line interface (CLI) can be used to configure and manage the switch
via the serial port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the CLI. Every command will be
introduced in terms of purpose, format, description, parameters, and examples.

Accessing the Switch via the Serial Port

The switch's serial port's default settings are as follows:
9600 baud
●
no parity
●
8 data bits
●
1 stop bit
●
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial
port configured as above are then connected to the switch's console port via an included RS-232 to RJ-45
convertor cable.
With the serial port properly connected to a management computer, the following screen should be
visible. If this screen does not appear, try pressing Ctrl+r to refresh the console screen.
Copyright(C) 2000-2011 Extreme Networks. All rights reserved.
UserName:admin
PassWord:
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
Using the Command-
Line Interface
EAS 200-24p Gigabit Ethernet Switch
Command Line Interface
Firmware: 1.00.007
19