Debug Output - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 19: Debug Software Command List

debug output

Description
Use the command to set a specified module's debug message output to debug buffer or local console. If
the user uses the command in a Telnet session, the error message also is output to the local console.
Format
debug output [module <module_list> | all] [buffer | console]
Parameters
module - Specifies the module list.
●
<module_list> - Enter the module list here.
●
all - Control output method of all modules.
●
buffer - Direct the debug message of the module output to debug buffer (default).
●
console - Direct the debug message of the module output to local console.
●
Restrictions
Only Administrator-level users can issue this command.
Example
To set all module debug message outputs to local console:
EAS 200-24p:admin# debug output all console
Command: debug output all console
Success.
EAS 200-24p:admin#
324
Extreme Networks EAS 200-24p Switch CLI Manual