Enable Ipif_Ipv6_Link_Local_Auto - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 11: Basic Commands Command List

enable ipif_ipv6_link_local_auto

Description
Enable the auto configuration of link local address when there are no IPv6 addresses explicitly
configured. When an IPv6 address is explicitly configured, the link local address will be automatically
configured, and the IPv6 processing will be started. When there is no IPv6 address explicitly configured,
by default, link local address is not configured and the IPv6 processing will be disabled. By enable this
automatic configuration, the link local address will be automatically configured and IPv6 processing
will be started.
Format
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters long.
●
all - Specifies that all the IP interfaces will be used.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the IP interface for IPv6 link local automatic:
EAS 200-24p:admin#enable ipif_ipv6_link_local_auto newone
Command: enable ipif_ipv6_link_local_auto newone
Success.
EAS 200-24p:admin#
236
Extreme Networks EAS 200-24p Switch CLI Manual