Extreme Networks EAS 200-24p Switch CLI Manual page 474

Chapter 30: Link Layer Discovery Protocol (LLDP) Command List
If EAPOL, GVRP, STP (including MSTP), and LACP protocol identity is enabled on this port and it is
enabled to be advertised, then this protocol identity will be advertised. The default state is disabled.
all - Specifies that all the vendor proprietary protocols will be advertised.
●
eapol - (Optional) Specifies that the EAPOL protocol will be advertised.
●
lacp - (Optional) Specifies that the LACP protocol will be advertised.
●
gvrp - (Optional) Specifies that the GVRP protocol will be advertised.
●
stp - (Optional) Specifies that the STP protocol will be advertised.
●
enable - Specifies that the protocol identity TLV according to the protocol specified will be
●
advertised
disable - Specifies that the protocol identity TLV according to the protocol specified will not be
●
advertised.
dot3_tlvs - Specifies that the IEEE 802.3 specific TLV data type will be configured.
●
all - Specifies that all the IEEE 802.3 specific TLV data type will be used.
●
mac_phy_configuration_status - (Optional) This TLV optional data type indicates that LLDP
●
agent should transmit 'MAC/PHY configuration/status TLV'. This type indicates it is possible for
two ends of an IEEE 802.3 link to be configured with different duplex and/or speed settings and
still establish some limited network connectivity. More precisely, the information includes
whether the port supported the auto-negotiation function, whether the function is enabled, the
auto-negotiated advertised capability, and the operational MAU type. The default state is
disabled.
link_aggregation - (Optional) This TLV optional data type indicates that LLDP agent should
●
transmit 'Link Aggregation TLV'. This type indicates the current link aggregation status of IEEE
802.3 MACs. More precisely, the information should include whether the port is capable of doing
link aggregation, whether the port is aggregated in a aggregated link, and the aggregated port ID.
The default state is disabled.
power_via_mdi - (Optional) This TLV optional data type indicates that LLDP agent should
●
transmit 'Power via MDI TLV'. Three IEEE 802.3 PMD implementations (10BASE-T, 100BASE-TX,
and 1000BASE-T) allow power to be supplied over the link for connected non-powered systems.
The Power Via MDI TLV allows network management to advertise and discover the MDI power
support capabilities of the sending IEEE 802.3 LAN station. The default state is disabled.
maximum_frame_size - (Optional) This TLV optional data type indicates that LLDP agent should
●
transmit 'Maximum-frame-size TLV. The default state is disabled.
enable - Specifies that the IEEE 802.3 specific TLV data type selected will be advertised.
●
disable - Specifies that the IEEE 802.3 specific TLV data type selected will be not advertised.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
474
Extreme Networks EAS 200-24p Switch CLI Manual