Extreme Networks EAS 200-24p Switch CLI Manual page 175

src_port_mask - Specifies an IPv6 Layer 4 UDP source port mask.
●
- <hex 0x0-0xffff> - Enter the Ipv6 UDP source port mask value here.
dst_port_mask - Specifies an IPv6 Layer 4 UDP destination port mask.
●
- <hex 0x0-0xffff> - Enter the Ipv6 UDP destination port mask value here.
icmp - (Optional) Specifies that the rule applies to ICMP traffic.
●
type - Specifies the type of ICMP traffic.
●
code - Specifies the code of ICMP traffic.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an egress access list profile with the name "eap-eth-bc" and assign the profile ID to be 1:
EAS 200-24p:admin#
eth-bc ethernet source_mac FF-FF-FF-FF-FF-FF
Command: create egress_access_profile profile_id 1 profile_name eap-eth-bc
ethernet source_mac FF-FF-FF-FF-FF-FF
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
create egress_access_profile profile_id 1 profile_name eap-
create egress_access_profile
175