Extreme Networks EAS 200-24p Switch CLI Manual page 792

Chapter 56: System Log Command List
udp_port - (Optional) Specifies the UDP port number.
●
<udp_port_number> - Enter the UDP port number used here.
●
ipaddress - (Optional) Specify IP address for the host.
●
<ipaddr> - Enter the IP address used for the configuration here.
●
<ipv6addr> - Enter the IPv6 address used for the configuration here.
●
state - (Optional) The syslog protocol is used for the transmission of event notification messages
●
across networks to a host. The option enables or disables the host to receive such messages.
enable - Specifies that the host to receive such messages will be enabled.
●
disable - Specifies that the host to receive such messages will be disabled.
●
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the syslog host configuration:
EAS 200-24p:admin# config syslog host all severiry debug facility local0
Command: config syslog host all severiry debug facility local0
Success.
EAS 200-24p:admin#
792
Extreme Networks EAS 200-24p Switch CLI Manual