Copy - Extreme Networks EAS 200-24p Switch CLI Manual

copy

Description
This command is used to copy a file to another file in the file system. A file located in a drive of a unit
can be copied to another file located in another drive of another unit.
For project that does not support file system on the flash, the system file such as runtime image/
configuration / prom /log can still be copied to media or from media that support sfile system via this
command using the reserved keyword. The keyword here refers to image_id, config_id, prom, or log.
Format
copy <pathname 32> <pathname 32>
Parameters
<pathname 32> - Specifies the file to be copied. The path name can be specified either as a full path
●
name or partial name. For partial path name, it indicates the file is in the current directory. This
name can be up to 32 characters long.
<pathname 32> - Specifies the file to copy to. The path name can be specified either as a full path
●
name or partial name. For partial path name, it indicates the file is in the current directory. This
name can be up to 32 characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To copy a file:
EAS 200-24p:admin# copy c:/log.txt c:/log1.txt
Command: copy c:/log.txt c:/log1.txt
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
copy
371