Config Time_Range - Extreme Networks EAS 200-24p Switch CLI Manual

config time_range

Description
This command defines a specific range of time to activate a function on the switch by specifying which
time range in a day and which days in a week are covered in the time range. Note that the specified
time range is based on the SNTP time or the configured time. If this time is not available, the time range
will not be met.
Format
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time
<time hh:mm:ss> weekdays <daylist> | delete]
Parameters
time_range - Specifies the name of the time range settings.
●
<range_name 32> - Enter the time range name used here. This name can be up to 32 characters
●
long.
hours - Specifies the time of a day.
●
start_time - Specifies the starting time of a day.
●
- <time hh:mm:ss> - Enter the starting time here. (24-hr time). For example, 19:00 means 7PM.
19 is also acceptable. The time specified in the start_time parameter must be smaller than the
time specified in the end_time parameter.
end_time - Specifies the ending time of a day. (24-hr time)
●
- <time hh:mm:ss> - Enter the ending time here. (24-hr time). For example, 19:00 means 7PM.
19 is also acceptable. The time specified in the start_time parameter must be smaller than the
time specified in the end_time parameter.
weekdays - Specifies the list of days contained in the time range. Use a dash to define a period of
●
days. Use a comma to separate specific days.
<daylist> - Enter the weekdays that will be included in this configuration here. For example,
●
mon-fri (Monday to Friday). sun, mon, fri (Sunday, Monday and Friday)
delete - Deletes a time range profile. When a time_range profile has been associated with ACL
●
entries, deleting the time_range profile will fail.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Extreme Networks EAS 200-24p Switch CLI Manual
config time_range
167