Config Snmp Linkchange_Traps Ports - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 54: Simple Network Management Protocol (SNMP) Command List

config snmp linkchange_traps ports

Description
This command is used to configure the sending of linkchange traps and per port control for sending of
change trap.
Format
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Parameters
all - To specify all ports.
●
<portlist> - To specify a port range.
●
enable - Enable sending of the link change trap for this port.
●
disable - Disable sending of the link change trap for this port.
●
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the sending of linkchange traps:
EAS 200-24p:admin# config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
EAS 200-24p:admin#
770
Extreme Networks EAS 200-24p Switch CLI Manual