Extreme Networks EAS 200-24p Switch CLI Manual page 88

Chapter 4: 802.1X Command List
max_req - (Optional) The maximum number of times that the authentication PAE state machine will
●
retransmit an EAP Request packet to the supplicant. Its default value is 2 and can be any integer
number among 1 to 10.
<value 1-10> - Enter the maximum required value here. This value must be between 1 and 10.
●
reauth_period - (Optional) It's a nonzero number of seconds, which is used to be the re-
●
authentication timer. The default value is 3600.
<sec 1-65535> - Enter the re-authentication period value here. This value must be between 1 and
●
65535 seconds.
enable_reauth - (Optional) You can enable or disable the re-authentication mechanism for a specific
●
port.
enable - Specifies to enable the re-authentication mechanism for a specific port.
●
disable - Specifies to disable the re-authentication mechanism for a specific port.
●
max_users - (Optional) Specifies per port maximum number of users. The default value is 16.
●
<value 1-448> - Enter the maximum users value here. This value must be between 1 and 448.
●
no_limit - Specifies that no limit is enforced on the maximum users used.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the parameters that control the operation of the authenticator associated with a port:
EAS 200-24p:admin#
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
EAS 200-24p:admin#
88
config 802.1x auth_parameter ports 1-20 direction both
Extreme Networks EAS 200-24p Switch CLI Manual