Config Max_Mcast_Group - Extreme Networks EAS 200-24p Switch CLI Manual

config max_mcast_group

Description
This command configures the maximum number of multicast groups that a port can join.
If the IPv4 or IPv6 option is not specified, IPv4 is implied.
When the joined groups for a port or a VLAN have reached the maximum number, the newly learned
group will be dropped if the action is specified as drop. The newly learned group will replace the eldest
group if the action is specified as replace.
Format
config max_mcast_group [ports <portlist> | vlanid <vlanid_list] {[ipv4 |
ipv6]} {max_group [<value 1-1024> | infinite] | action [ drop | replace]}(1)
Parameters
ports - Specifies the range of ports to configure the max_mcast_group.
●
<portlist> - Enter the list of ports to be configured here.
●
vlanid - Specifies the VLAN ID to configure max_mcast_group.
●
<vlanid_list> - Enter the VLAN ID list here.
●
ipv4 - (Optional) Specifies that the maximum number of IPv4 learned addresses should be limited.
●
ipv6 - (Optional) Specifies that the maximum number of IPv6 learned addresses should be limited.
●
max_group - (Optional) Specifies the maximum number of multicast groups. The range is from 1 to
●
n or infinite. "Infinite" means that the maximum number of multicast groups per port or VLAN is
not limited by the switch, which is project dependent.. "n" is based on the project.
<value 1-1024> - Enter the maximum group value here. This value must be between 1 and 1024.
●
infinite - Specifies that the maximum group value will be set to infinite.
●
action - (Optional) Specifies the action for handling newly learned groups when the register is full.
●
drop - The new group will be dropped.
●
replace - The new group will replace the eldest group in the register table.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Extreme Networks EAS 200-24p Switch CLI Manual
config max_mcast_group
551