Extreme Networks EAS 200-24p Switch CLI Manual page 156

Chapter 6: Access Control List (ACL) Command List
- <value 0-65535> - Enter the TCP destination port value here. This value must be between 0
and 65535.
mask - Specifies an additional mask parameter that can be configured.
●
- <hex 0x0-0xffff> - Enter the TCP destination port mask value here.
udp - (Optional) Specifies to configure the UDP parameters.
●
src_port - Specifies the value of the IPv6 Layer 4 UDP source port.
●
- <value 0-65535> - Enter the UDP source port value here. This value must be between 0 and
65535.
mask - Specifies an additional mask parameter that can be configured.
●
- <hex 0x0-0xffff> - Enter the UDP source port mask value here.
dst_port - Specifies the value of the IPv6 Layer 4 UDP destination port.
●
- <value 0-65535> - Enter the UDP destination port value here. This value must be between 0
and 65535.
mask - Specifies an additional mask parameter that can be configured.
●
- <hex 0x0-0xffff> - Enter the UDP destination port mask value here.
icmp - (Optional) Specifies to configure the ICMP parameters used.
●
type - Specifies that the rule applies to the value of ICMP type traffic.
●
- <value 0-255> - Enter the ICMP type traffic value here. This value must be between 0 and 255.
code - Specifies that the rule applies to the value of ICMP code traffic.
●
- <value 0-255> - Enter the ICMP code traffic value here. This value must be between 0 and 255.
port - Specifies the port list used for this configuration.
●
<portlist> - Enter a list of ports used for the configuration here.
●
all - Specifies that all the ports will be used for this configuration.
●
vlan_based - Specifies that the rule will be VLAN based.
●
vlan - Specifies the VLAN name used for this configuration.
●
- <vlan_name> - Enter the VLAN name used for this configuration here.
vlan_id - Specifies the VLAN ID used for this configuration.
●
- <vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
permit - Specifies that packets matching the access rule are permitted by the switch.
●
priority - (Optional) Specifies that the priority of the packet will change if the packet matches the
●
access rule.
<value 0-7> - Enter the priority value here. This value must be between 0 and 7.
●
replace_priority - (Optional) Specifies that the 802.1p priority of the outgoing packet will be
●
replaced.
replace_dscp_with - (Optional) Specifies that the DSCP of the outgoing packet is changed with the
●
new value. If using this action without an action priority, the packet will be sent to the default TC.
<value 0-63> - Enter the replace DSCP with value here. This value must be between 0 and 63.
●
replace_tos_precedence_with - (Optional) Specifies that the IP precedence of the outgoing packet is
●
changed with the new value. If used without an action priority, the packet is sent to the default TC.
<value 0-7> - Enter the replace ToS precedence with value here. This value must be between 0
●
and 7.
counter - (Optional) Specifies whether the ACL counter feature is enabled or disabled. This
●
parameter is optional. The default option is disabled. If the rule is not bound with the flow_meter, all
156
Extreme Networks EAS 200-24p Switch CLI Manual