Config Sflow Flow_Sampler - Extreme Networks EAS 200-24p Switch CLI Manual

config sflow flow_sampler

Description
This command configures the sFlow flow sampler parameters. In order to change the
analyzer_server_id, delete the flow_sampler first and create a new one.
Format
config sflow flow_sampler ports [<portlist> | all] {rate <value 0-65535> |
maxheadersize <value 18-256>}
Parameters
ports - Specifies the list of ports to be configured.
●
<portlist> - Enter the list of ports that will be used for this configuration here.
●
all - Specifies all ports on the switch.
●
rate - (Optional) The sampling rate for packet Rx sampling. The configured rate value multiplied by
●
x is the actual rate, where the x is project dependent with the default value 256. If set to 0, the
sampler is disabled. If the rate is not specified, its default value is 0.
<value 0-65535> - Enter the sampling rate value here. This value must be between 0 and 65535.
●
maxheadersize - (Optional) The maximum number of leading bytes in the packet which has been
●
sampled that will be encapsulated and forwarded to the server. If not specified, the default value is
128.
<value 18-256> - Enter the maximum header size value here. This value must be between 18 and
●
256.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Configure the sFlow sampler the rate of port 1 to be 0:
EAS 200-24p:admin# config sflow flow_sampler ports 1 rate 0 tx_rate 1
Command: config sflow flow_sampler ports 1 rate 0 tx_rate 1
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
config sflow flow_sampler
705