Enable Snmp Linkchange_Traps - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 54: Simple Network Management Protocol (SNMP) Command List

enable snmp linkchange_traps

Description
This command is used to configure the sending of linkchange traps.
Format
enable snmp linkchange_traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the sending of linkchange traps:
EAS 200-24p:admin# enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
EAS 200-24p:admin#
768
Extreme Networks EAS 200-24p Switch CLI Manual