Config Sflow Analyzer_Server - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 51: sFlow Command List

config sflow analyzer_server

Description
Configures the receiver information. You can specify more than one collector with the same IP address
if the UDP port numbers are unique.
Format
config sflow analyzer_server <value 1-4> {timeout [<sec 1-2000000> | infinite]
| collectoraddress <ipaddr> | collectorport <udp_port_number 1-65535> |
maxdatagramsize <value 300-1400>}
Parameters
analyzer_server - The ID of analyzer server.
●
<value 1-4> - Enter the analyzer server ID here. This value must be between 1 and 4.
●
timeout - (Optional) The time (in seconds) remaining before the sample is released and stops
●
sampling. When the analyzer_server times out, all of the flow_samplers and counter_pollers
associated with this analyzer_server will be deleted.
<sec 1-2000000> - Enter the time-out value here. This value must be between 1 and 2000000
●
seconds.
infinity - Indicates the analyzer server never timeout
●
collectoraddress - (Optional) The IP address of the server. If not specified or set a 0 address, sFlow
●
packets will not be sent to this server.
<ipaddr> - Enter the IP address used for the configuration here.
●
collectorport - (Optional) The destination UDP port for sending the sFlow datagram. If not specified,
●
the default value is 6364
<udp_port_number 1-65535> - Enter the destination port number here. This value must be
●
between 1 and 65535.
maxdatagramsize - (Optional) The maximum number of data bytes that can be packed in a single
●
sample datagram. If not specified, the default value is 1400 bytes.
<value 300-1400> - Enter the maximum datagram size here. This value must be between 300 and
●
1400.
Restrictions
Only Administrator and Operator-level users can issue this command.
712
Extreme Networks EAS 200-24p Switch CLI Manual