Config Authen Server_Group - Extreme Networks EAS 200-24p Switch CLI Manual

config authen server_group

Description
This command is used to add or remove an authentication server host to or from the specified server
group. Built-in server group "tacacs", "xtacacs", "tacacs+", "radius" accepts the server host with the
same protocol only, but user-defined server group can accept server hosts with different protocols.
Format
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string 15>]
[add | delete] server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ |
radius]
Parameters
server_group - User-defined server group.
●
tacacs - Built-in server group "tacacs".
●
xtacacs - Built-in server group "xtacacs".
●
tacacs+ - Built-in server group "tacacs+".
●
radius - Built-in server group "radius".
●
<string 15> - Enter the server group name here. This value can be up to 15 characters long.
●
add - Add a server host to a server group.
●
delete - Remove a server host from a server group.
●
server_host - Server host's IP address.
●
<ipaddr> - Enter the server host IP address here.
●
protocol - Specifies the authentication protocol used.
●
tacacs - Specifies that the TACACS authentication protocol will be used.
●
xtacacs - Specifies that the XTACACS authentication protocol will be used.
●
tacacs+ - Specifies that the TACACS+ authentication protocol will be used.
●
radius - Specifies that the radius authentication protocol will be used.
●
Restrictions
Only Administrator-level users can issue this command.
Extreme Networks EAS 200-24p Switch CLI Manual
config authen server_group
129