If the command is specified without an operand, you are prompted to enter the
speed value.
The output of the portshow command displays the current achieved speed for
the port, and the portcfgshow command displays the desired speed setting for
the port.
Operands
This command has the following operands:
Example
Specifying the speed of port 3 on the port card in slot 2 to 2 Gbit/sec:
See Also
Also see the following related commands:
ISL Trunking Version 3.1.x/4.1.x User Guide
slotnumber - Specify the number of the blade that the port belongs to. This
operand is optional.
portnumber - Specify the port number where you want to set the speed.
This operand is required.
speedlevel - Specify the speed of the port. This operand is optional. Valid
level values are one of the following:
— 0 - Auto-negotiating mode. The port automatically configures for the
highest speed.
— 1 - 1 Gbit/sec mode. The port will be at fixed speed of 1 Gbit/sec.
— 2 - 2 Gbit/sec mode. The port will be at fixed speed of 2 Gbit/sec.
switch:admin> portcfgspeed 2/3 2
done.
switchcfgspeed
portshow
ISL Trunking Commands
49