Rebooting The System; Vls9000 Node Led Status During Normal Operation - HP StorageWorks 9000 - Virtual Library System User Manual

6. Confirm that the VLS components are all functioning normally and the VLS is cabled correctly by
observing the condition of their status LEDs. The LED status should match those shown in the
following table.
If an LED status does not match the status shown in the following table, a component needs
attention.
Figure 41 VLS9000 node LED status during normal operation
.
Item
1
2
3
4
5
7. Rebooting the system is complete when you receive the "Initializing node#", then "Initializing for
node# completed." messages for all nodes in the systems notifications.

Rebooting the System

To reboot the system from VLS CLI:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. Open a secure shell session and log in as the administrator. See
"Opening a Secure Shell
3. Initiate a reboot of the VLS by entering:
restartSystem
To reboot the system from Command View VLS:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. Open a Command View VLS session and log in as the administrator. See
"Opening a Command View VLS Session from a Web
3. Under the System tab, select Chassis in the navigation tree.
Description
Internal health LED
External health LED (power supply)
NIC 1 link LED
NIC 2 link LED
Power supply LEDs
Session" on page 146.
Status
LED is green.
LED is green.
LED is green if primary node. LED is off if
secondary node.
LED is green.
LED is green.
Browser" on page 143.
HP StorageWorks 137