Default Rmon Configuration; Configuring Rmon Alarms And Events - Cisco Catalyst 2960 Software Configuration Manual

Chapter 28 Configuring RMON
Configuring RMON
•
•
•
•

Default RMON Configuration

RMON is disabled by default; no alarms or events are configured.

Configuring RMON Alarms and Events

You can configure your switch for RMON by using the command-line interface (CLI) or an
SNMP-compatible network management station. We recommend that you use a generic RMON console
application on the network management station (NMS) to take advantage of the RMON network
management capabilities. You must also configure SNMP on the switch to access RMON MIB objects.
For more information, see
Note 64-bit counters are not supported for RMON alarms.
OL-26520-01
Default RMON Configuration, page 28-3
Configuring RMON Alarms and Events, page 28-3
Collecting Group History Statistics on an Interface, page 28-5
Collecting Group Ethernet Statistics on an Interface, page 28-6
Chapter 30, "Configuring SNMP."
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
(required)
(optional)
(optional)
Configuring RMON
28-3