Configuring The Global Parameters - Cisco 2500 Series Installation And Configuration Manual

Configuring the Router
cable is not connected, the router boots from Flash memory and goes into the setup facility.
Note You can run the setup facility any time from the enable prompt (#) by entering the setup command.

Configuring the Global Parameters

You use the setup facility to configure the global parameters, which are used for controlling system-wide
settings. Take the following steps to enter the global parameters:
Step 1 Connect a terminal by following the instructions in the section
Modem" in the chapter
Step 2 After booting from Flash memory, the following information appears after about 30 seconds.
Note The messages displayed vary, depending on the Cisco IOS release and feature set you selected. The
screen displays in this section are for reference only and may not exactly reflect the screen displays on your
console.
When the following information is displayed, you have successfully booted the router:
System Bootstrap, Version X.X(Xa), SOFTWARE
Copyright (c) 19XX-19XX by Cisco Systems
2500 processor with 16384 Kbytes of main memory
Loading igs-c-l.110-0.7 at 0x3000040, size = 3865444 bytes [OK]
F3: 3779532+85880+173868 at 0x3000060
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 3000 Software (IGS-C-L), Version 11.0(5), SOFTWARE
Copyright (c) 19XX-19XX by cisco Systems, Inc.
Compiled Mon 19-Jun-XX 23:22 by
Image text-base: 0x030200E4, data-base: 0x00001000
Cisco 2500 (68030) processor (revision C) with 16380K/2048K bytes of
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520cfg.htm (5 of 16) [10/27/2000 3:07:51 PM]
"Installing the Router" and then boot the router to the user EXEC prompt (Router>).
"Connecting the Console Terminal and