Honda Civic Service Manual page 981

ATF Filter
l .
Removal/lnstallation
!@
Make sure lifts, lEcks, snd safoty stands
ara pl8ced properly {sae section 1).
CAUTION: While removing and installing the ATF tilier,
be sure not to allow dust or other for6ign particle3 to
enter thg transmission.
1.
Raise the front of the vehicle, and support it with
safety stands (see section 1).
2.
Set the parking brake, and block both rear wheels
securely.
3 . R e m o v e t h e d r a i n p l u g , a n d d r a i n t h e C V T f l u i d .
Reinstall the drain plug with a new sealing washer
{see page 14-299).
f l ,
5 .
CAUTION: Keep all toreign particles out ot the
transmission.
Remove the ATF cooler hoses at the ATF cooler
lines. Turn the ends of the ATF cooler hoses up to
prevent ATF from flowing out, then plug the ATF
cooler noses.
CAUTION: Keep all foreign particles out of the
transmission.
Remove the right front mounvbracket.
10 x 1.25 mm
4{ N.m {i1.5 kgf.m,33 lbf ft)
ATF COOLER LINE
10 x 1.25 mm
54 N.m {5.5 kgt'm,
40 rbl.ft)
ATF COOLER HOSE
( | ' t
1 4- 30 3
6. Remove the ATF cooler outlet line.
7. Remove the ATF cooler line bracket bolt.
8. Remove the ATF pan (fourteen bolts)
9. Remove the ATF cooler inlet line from the ATF pan
(three bolts).
10. Remove the ATF filter, and clean it.
11. Check that the ATF filter is in good condition.
12. Replace the ATF filter if it is clogged.
LINE BOLT
28 N.m {2.9 kgf.m,21 lbt.ft)
ATF COO1TR OUTIET
6 x 1 . 0 m m
ATF COOLER INI-ET
LINE ERACKET BOLT
8 x 1.25 mm
26 N.m (2.7 kgt.m,
20 rbtftt
O.RING
Replace.
ATF
ATF FILTER
ATF PAN
6 x 1 . 0 m m
12 N.m (1.2 kgt'm,8.7 lbl'ft)
l n s t a l l t h e A T F f i l t e r i n t h e r e v e r s e o r d e r o f t h e
removal procedure.
GAUTION: Keep all foreign particles out ot the
transmission,
NOTE:
R e p l a c e t h e O - r i n g s , t h e A T F p a n g a s k e t a n d
sealing washers.
l f t h e A T F c o o l e r i n l e t l i n e b r a c k e t i s b e n t o r
warped. put it back to the original position
GASKET
Replace.
'13.
12 N m (1.2 kgf m,