Honda Civic Service Manual page 1175

1 .
Clean the piston and caliper bore with brake fluid,
and inspect for wear and damage.
Coat a new Diston seal with the recommended rub-
ber grease in the caliper seal set, and installthe seal
in the cylinder groove.
Apply the recommended seal grease in the caliper
seal set to the sealing lips and inside ol a new pis-
ton boot, and securely install it in the caliper with a
new boot clip.
CAUTION: Be carelul not to damage ths calipor
cylinder wall.
Replace.
=_.
-1!!4!!n
RUBEER GREASE
I J
Replace.
-6,
SILICONE GREASE
t . /
4.
Lubricate the caliper and piston with brake fluid,
t h e n i n s t a l l t h e p i s t o n i n t h e c y l i n d e r w i t h t h e
dished end facing in.
Apply the recommended seal grease in the caliper
seal set to the sliding surface oJ sleeve B and the
inside of the new pin and sleeve boots.
lnstall the new sleeve and pin boots 8nd sleeve B
on the caliDer.
NOTE: Make sure to install the boots into the grooves
in the caliper and sleeve B properly.
SI.EEVE BOOT
Y
P IN BOOT
Replace.
(cont'd)
1 9 - 1 9
SLEEVE B