Honda Civic Service Manual page 1280

Ouarter Glass
Installation (cont'dl
8. With a sponge, apply a light coat of body primer to
the original adhesive remaining around the quarter
glass opening flange. Let the body primer dry for at
least l0 minutes.
NOTE:
. Do not apply glass primer to the body, and be
c a r e f u l n o t t o m i x u p g l a s s a n d b o d y p r i m e r
sponges.
.
Never louch the primed surfaces with your hands.
.
Mask off the rear side trim panel before painting
the flange.
///ffi
: Appty aoay primer here.
1 6 m m
10.63 in.l
Thoroughly mix the adhesive and hardener togeth-
er on a glass or metal plate with a putty knife.
NOTE:
. Clean the plate with a sponge and alcohol before
m i x i n g .
. Follow the instructions that came with the adhe-
sive.
Before filling a cartridge, cut the end of the nozzle
as shown.
Cul nozzle end
10 mrn (0.39 in.)
9 .
1 0 .
20-4A
7 mm 10.27 in.)
l'1. Pack adhesive into the canridge without air pockets
to ensure continuous delivery. Put the cartrige in a
c a u l k i n g g u n , a n d r u n a b e a d o f a d h e s i v e a r o u n d
the edge of the quarter glass as shown.
NOTE:
. lf the old quarter glass is to be reinstalled, peel
the separator off the butyl tape after applying the
adhesive.
.
Peel the separator off the adhesive tape after
applying the adhesive.
. Apply the adhesive within 30 minutes after apply
ing the glass primer.
1 2 m m 1 1
lo.tt tn.l I l:ADHESIVE
8 m m
{0.31 in.)
CLIP
MOLDING