Honda Civic Service Manual page 1320

Rear Seat Belt
Replacement
CAUTION: Chack the rear seat belts for damage, and
replace them if necessary, 8e carolul not to damage
lhem during removal and installation.
Rear seat belt removal {2Dl4D}:
1 . R e m o v e :
.
Rear seat cushion (see pages 20-79, 81)
.
Rear seat-back (2D, see page 20-81)
. Side trim panel (2D, see page 20-61)
.
Rear shelf (see pages 20-59,61)
. Rear trim panel {see page 20-62}
. Trunk side trim, Japan-produced (see page 20-62)
. Trunk trim panel, USA-produced (see page 20-62)
2. Remove all the anchor bolts and retractor bolt, then
remove the rear seat belt and retractor.
UPPER ANCHOR BOLT
7/16-20 UNF
32 N.m (3.3 kgf.m,2,1 lbtft)
RETNACTOR BOLT
7/1F20 UNF
32 N.m {3.3 kgf.m,
24 tbt.ft)
7/16-20 UNF
32 N.m {3.3 kgf.m,24lbt.ft)
20-88
R€TRACTOB
3.
Installation is the reverse of the removal procedure.
NOTE:
. Check that the retractor locking mechanism func-
tions as described on page 20-91.
.
lvlake sure you assemble the washers and collar
on the upper anchor bolt as shown.
. Before installing the anchor bolt. make sure there
are no twists or kinks in the rear seat belt.
Upper anchor boh condruqtion:
SPRING
WASHER
Lower anchor bolt construction:
LOWER ANCXOR
EOLT
LOWER ANCHOR
Retractor bolt construction:
RETRACTOR
BOLT
t7\ /7--^,
l/rn\ .----. A -nrfi|lH \
tr\7-\
/ \ \
TOOTHED
LOCK WASHER