Honda Civic Service Manual page 969

Linear Solenoids/lnhibitor Solenoid
)
Test
1. Disconnect the 8P connector from the solenoid har-
ness connector.
SOLENOID HARNESS
CONNECTOR
ATF OIPSTICK
Measure the resistance of the shift control linear
solenoid between the No. 3 and No. 7 terminals of
the solenoid harness connector.
Measure the resistance of the PH-PL control linear
solenoid between the No. 2 and No. 6 terminals
Measure the resistance of the start clutch control
linear solenoid between the No 4 and No. 8 termi-
nats,
S T A N D A R D : 3 8 - 6 . 8 O
M e a s u r e t h e r e s i s t a n c e o f t h e i n h i b i t o r s o l e n o i d
between the No. 5 terminal and body ground
S T A N D A R D : 1 1 . 7
- 2 1 . 0 O
R e p l a c e t h e l o w e r v a l v e b o d y a s s e m b l y i f a n y
solenoid resistance is not within its standard.
7.
lf all ot the resistances are within the standard, a
c l i c k i n g s o u n d s h o u l d b e h e a r d w h e n c o n n e c t r n g
the batterv terminals to the solenoid harness con-
nector terminals below:
Shift control linear solsnoid
No.3: Batterv Positive terminal
No. 7: Battery negative terminal
PH-PL control linear solenoid
No.2: Batterv oositive terminal
No. 6: Baftery negative terminal
Start clutch control linear solenoid
No. 4: Battery Positive terminal
No.8: Battery negative terminal
lnhibitor solsnoid
No,5: Batterv Positive terminal
Body ground: Battery negative termrnal
SOLENOID HARNESS CONNECTOR
Terminal side of male terminals
l f n o c l i c k i n g s o u n d i s h e a r d , r e p l a c e t h e l o w e r
valve body assemblY,
NOTE: lf the lower valve body assembly replace-
ment is required, see Lower Valve Body Assembly
Replacement (page 14-302).
14-291