Honda Civic Service Manual page 1043

Driveshafts
Reassembly
U.S. and Canada-Producad Driv€shafts
Note these items during reassembly'
. Clean the disassembled parts with solvent, and dry them thoroughly with compressed air, Do not wash the rubber
pans with solvent.
o ;..jl@l
: Thoroughly pack the inboard joint and both joint boots with the joint grease included in the new driveshaft
ser,
Grease quantity:
lnboard Joint
1 1 5 - 1 3 5 g ( 4 . 0 - 4 . 8 o z )
Outboard Joint
1 1 5 - 1 3 5 g ( 4 . 0 - 4 . 8 o z )
. The'98 Canada model and all '99 - 00 models uses a TPE (Thermoplastic Polyester Elastomerl outboard joint boot. Use
the ear clamp type boot band in the outboard joint boot set.
STOP RING
('96 - 98 models)
-6r
Pack cavity with grease.
DYNAMIC DAMPER
OOUBI.S LOOP BAND
Replace.
INBOARD BOOT
-6l
Pack cavity with grease.
EAB CLAMP BAND
Replace.
STOP RING
Replace.
EAR CLAMP BAND
Replace.
DRIVESHAFT
OUTBOARD
BOOT ITPE)
-6ll
,
Pack cavity with grease.
EAR CLAMP BAND
Replace.
-G.1
CIRCLIP
1 6 - 8
OUTBOARD JOINT