1 0 - 1 2 m m
lf deflection is not within specs' loosen the locknut'
turn the adjusting nut untilthe deflection is as speci-
fied, then retighten the locknut.
With the cable properly adiusted, check the thronle
valve to be sure it opens fully when you push the
accelerator pedal to the floor. Also check the throt-
tle valve to be sure it returns to the idle position
whenever you release the accelerator pedal'
Dl6Y5, Dr6Y8, D16Y, €ngine:
1. Open the throttle valve fully, then install the throttle
cable in the throttle linkage, and install the cable
housing in the cable bracket.
D16Y5, D16Y8 engins:
Start the engine. Hold the engine at 3,000 rpm with
n o l o a d ( i n P a r k o r n e u t r a l ) u n t i l t h e r a d i a t o r f a n
comes on, then let it idle.
Hold the cable sheath. removing all slack from the