Honda Civic Service Manual page 931

Troubleshooting Flowchart - Inhibitor Solenoid
NOTE: Record all treeze data betore you troubleshoot
Po$ibls Cause
. Dbconnected solenoid hatness
connedor
' Short or opon in inhibitor sole'
noid wire
. Faultv inhibitor solenoid
SOLENOID HARNESS
8P CONNECTOR
Terminal side of male terminals
. OBD ll Scan Tool indic.td Code
P1882.
. Selt-di.gnGis E indicator lighl
indic.tos Code 33.
Mea3ure Inhibhor Solenoid Resid-
ance at the sol€noid Harness
Connector:
1. Disconnect the 8P connector
f r o m t h e s o l e n o i d h a r n e s s
connector.
2 . M e a s u r e t h e
r e s l s t a n c e
betlveen the No 5 terminal of
the solenoid harness connec-
tor and body ground.
ls the resistance 11.7 - 21 0 0?
Check Inhibitor Solenoid lor a
Short Circuii:
1 . D i s c o n n e c t t h e B ( 2 2 P ) c o n -
nector from the TCM.
2. Check for continuity between
t h e B 1 t e r m i n a l a n d b o d y
gro!no.
Repair rhort in the wire ltetwegn
the 81 dnd the bodY ground.
Mea$rr€ Inhibitor Solenoid ResBt'
anoe:
1. Connect the 8P connector to
the solenoid harness connec_
IOr.
2 . M e a s u r e t h e
r e s i s t a n c e
b e t w e e n t h e B l a n d b o d y
g r o u n d .
Reoair loose terminal or open in
the wire betwean the 81 and the
solenoid hame3s connector'
ls the resistance 11.7 - 21.0 O?
Ch6ck for loose TCM connectors.
ll necessary, substhule a known_
good TCM and techeck.
Wire side of female terminals
14-253