Honda Civic Service Manual page 1188

Rear Brake Caliper
Reassembly (cont'dl
L
PARKING NUT
28 N.m (2.8 kgt m,
20 rbr.trt
Pack all cavities of the needle bearing with the rec,
ommended rubber grease in the caliper seal set,
Coat a new cam boot with recommended rubber
grease in the caliper seal set, and install it in the
caliper body.
SPRII{G
WASHEN
z .
.-_e!!!9!.{
RUBBER
GREASE
Apply recommended rubber grease in the caliper
seal set to the pin contacting area of the cam, and
install the cam and lever assembly into the caliper
bodv.
lnstall the return spring.
CAUTION:
. When the cam and lever wgre separatod. b€ surg
to assemble them bofore installing the cam in
the caliper body, Install the lev€r and spring
washer. apply locking agent to the threads, and
tighten the parking nut while holding the l.vor
whh a vise,
. Avoid damaging the cam boot since it must bs
installed before thg cam.
. When installing the cam, do nol allow the cam
boot lips lo turn outside in.
19-32
5 . I n s t a l l t h e p i n i n t h e c a m .
O.RING
Replace.
SLEEVE PISTON
Install a new O-ring on the sleeve pisron.
Install the sleeve piston so that the hole in the bot-
tom of the piston is aligned with the pin in the cam,
and the two pins on the piston are aligned with the
holes in the calioer.
Coat a new cup with recommended rubber grease
in the caliper seal set, and install it with its groove
facing the bearing A side of the adjusting bolt.
7 .
€8.--:BTif
@'-.-3nfi""'i"
@--seacrn
$
eeenrne a
fi,*,*^"
GF-
Fit the bearing A, spacer. adjusting spring B, and
spring cover on the adjusting bolt, and install them
in the caliDer cvlinder.
CUP
Replace.
=^.
#-g!!!!!Jl
RUBBER GREASE
o